Manual routing of connectors between tools

[Tim_Slade]

We have a lot of workflows with a lot going on in them, as I'm sure a lot of you do.

Sometimes, the way that Alteryx draws the connections between tools is loopy, literally.

It would be very helpful if we could explicitly control how the connectors were routed, as this would allow us to prevent them from cutting across other complex areas of the workflow.

Also if we could bundle the connectors (think tying together a bunch of cables with a cable tie) so that things that were heading to the same part of the canvas could route there as a bundle.

[KylieF]

Thank you for your idea! We appreciate all the feedback provided especially around the user experience design and the workflow experience. Like I mentioned on your other idea, if you haven't checked out our Submission Guidelines be sure to as it goes over the process and boards as a whole.