Unique Tool not working properly
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hey everybody,
I am having trouble with the unique tool in my workflow. This is even more surprising since this worked up until now and I haven't changed anything about my workflow.
The unique tool receives an input but the output is not working, regardless of which column I choose to find the values from.
I use the same build of that specific part three times in my workflow which run on a parallel basis, it works only once, even though the setup is identical.
Any ideas what the issue here could be?
Thanks in advance!
Solved! Go to Solution.
- Labels:
- Dynamic Processing
- Preparation
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi @Cela
Can you try replacing the unique tool once.
Delete it and create a new one with same settings please.
Many thanks
Shanker V
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi @ShankerV ,
thank you for the quick response!
I actually did check this beforehand, the columns contain data which would mean that I normally could see results in the U- or D-path. That is unfortunately not the case here.
I also tried removing the unique tool now and letting the incoming input go through a simple select tool, yet no output here either.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
will you be able to share the configurations you have made into the tool?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
I have built a mock workflow to simply show the tools used, but I cannot replicate the error that I receive in the other workflow.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hey guys,
I retraced every single step in the workflow and found my error. It's a very amusing one because I didn't pay attention to it at all 😄
At some point in my testing phase, I deactivated the containers of the two paths but kept them open so it didn't occur to me that this might have been the issue.
Thank you for your help!
![](/skins/images/6056C79A596CAB15526D64C598622101/responsive_peak/images/icon_anonymous_message.png)