Unique Tool not working properly

Hey everybody,

I am having trouble with the unique tool in my workflow. This is even more surprising since this worked up until now and I haven't changed anything about my workflow.

The unique tool receives an input but the output is not working, regardless of which column I choose to find the values from.

I use the same build of that specific part three times in my workflow which run on a parallel basis, it works only once, even though the setup is identical.

Any ideas what the issue here could be?

Thanks in advance!

Dynamic Processing

Preparation

Accepted answers

Cela

Hey guys,
I retraced every single step in the workflow and found my error. It's a very amusing one because I didn't pay attention to it at all 😄
At some point in my testing phase, I deactivated the containers of the two paths but kept them open so it didn't occur to me that this might have been the issue.

Thank you for your help!

All comments

ShankerV

Hi @Cela

Can you try replacing the unique tool once.

Delete it and create a new one with same settings please.

Many thanks

Shanker V

Cela

Hi @ShankerV ,

thank you for the quick response!
I actually did check this beforehand, the columns contain data which would mean that I normally could see results in the U- or D-path. That is unfortunately not the case here.

I also tried removing the unique tool now and letting the incoming input go through a simple select tool, yet no output here either.

Raj

will you be able to share the configurations you have made into the tool?

Cela

I have built a mock workflow to simply show the tools used, but I cannot replicate the error that I receive in the other workflow.

Cela

Thank you for your help!

Quick Links

This months top contributors

mceleavey 383

mbarone 337

Hollingsworth 335

LanisC 335

RithiS 280