Base Map Does Not Appear
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
After adding a Map Input to the canvas and setting the Base Map as "Alteryx Light - Most Recent Vintage" or any other Base Map for that matter, it doesn't show anything. The part of the configuration that should show the map is still gray. This is my first time using the Map Input tool so it's the first time I've encountered this problem.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
"Alteryx Light" is installed with Alteryx Designer and should always be available. Even if you zoom in and pan around the map it never works? This might be an installation problem then and you might need to re-install.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi, I have the exact same issue, using Alteryx Light - Most Recent Vintage as a Base map configuration.
- If I download a workflow that uses map input, I can actually see the rendered map in the browse tool. However, I cannot see the base map on the map input config (clicking on map input icon). There I can only a drawn line or polygon but it appears on a grey canvas, not on a map.
- If I add my own map input tool to the canvas and add a browse I cannot see base map in either of them. In both cases it shows as a blank grey canvas.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
I am also getting the same results. No "Alteryx Light" base map shown on the map input tool. I also can see the base map in a browser tool, but no base map shows in the map input tool.
Has anyone found a solution for this?
Using Designer Version: 2024.2.1.73 Patch: 2.
 
