ODBC Driver Issue When Exporting Workflow
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi,
My workflow is setup to connect to our MySQL Database through an ODBC connector.
When I export my workflow and share it with others, they are not able to run the workflow and receive the error attached. They have to re-setup the ODBC connector on their own computer in order to run the workflow.
Is there a way to export the workflow so they don't have to go through the setup again on their own computer?
Thanks!
Johnny
Solved! Go to Solution.
- Labels:
- Tips and Tricks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi Johnny.
I stopped using ODBC a while back sa the aliass gave a lot of headaches. However, if you cannot use OLEDB instead, maybe this can help.
1. Is there a 32/64 bit issue here? Is it installed in 32bit on one machine and 64 bit on another?
2. Is it installed in "User DSN" on one machine and "System DSN" on another?
3. Make sure that you are using ODBC alisass and not Alteryx aliass for ODBC connections. This is a cause for a lot of confusion.
Hope it helps!
Best,
Jess
