Hi
I've a flow where i add messages to a servicebus. But for the most part the flow has to be run, several times before doing the final run.
So I don't want to add messages to the que everu time, therefore I need a smooth solution, where I can pass data even if the servicebus container is disabled.
I've done this. But I assume this can be done smarter?
Solved! Go to Solution.
Hey @Hamder83, not sure if it's that much more succinct, but have you tried looking into the Detour tool(s)? Using these, you can basically send your workflow in a different direction - in your case, this would be one way if it's the final run where you want messages adding, and another way if it's an earlier run where you don't want them added.
Here's a quick example:
Starting data:
'Detour to the Right' is NOT ticked so the workflow follows the treatment of the left stream (in this example, nothing):
Output:
Whereas if we detour the run to the right, the workflow follows the treatment of the right stream:
Perhaps this can be useful so you can do earlier/test runs under one stream and then just tick the detour for your final runs. Hope it helps either way!
Hi @DataNath , i was looking at it, but I wanted to do it dynamic.
I'll accept as solution since it for some can serve their purpose :-)