Dear's ,
I have AAP1 and AAP2 .
AAP2 data is dependent on AAP1 selection as shown below .
But when i select multiple values in AAP1 in above pic , it fails to call AAP2 .
Any issue here.
Thanks.
Hi @praneshsapmm
Please refer WeeklyChallenge #175(Tire Size Calculator).
https://community.alteryx.com/t5/Weekly-Challenge/Challenge-175-Tire-Size-Calculator/td-p/447639
This challenge is good examination for chained app.
List boxes in Chained apps only work with ”ExternalSource” option.The only way to change the choices dynamically is to use an "ExternalSource" option.
So you have to save the selection for app2 in chained app1
The first app works well because you have "executed" the workflow.
Hi @AkimasaKajitani ,
Both the AAP's work well when i only check only one option . But they fail when i select multiple options .
I think i have to try passing values by formula instead of default value .
But not sure how to do .
When you say that App2 fails to be called after running App2 have you set this up to run in the Interface designer.
As @AkimasaKajitani suggests check out the weekly challenges with chained apps in, and there is also this interactive lesson - https://community.alteryx.com/t5/Interactive-Lessons/Chaining-Analytic-Apps/ta-p/243120
When using a list box there is an option to create a custom list
Then you can pass that value into a filter tool to only pass specific results downstream, for example if in my main workflow I have a filter that is set to use a IN filter.
Then if I update the first app multi check box, as per the example
Then the filter tool will be updated to do this:
Which I think meets your use case?
Hi @cgoodman3 ,
Here are Scenario :
When i select one option in AAP1 :
AAp2 results are shown as below :
Whereas i select multiple options :
AAP2 results are not shown .
Is it because iam passing single default value .
Thanks
Hi
So with mock data you've got something like this
AccountNumber,Company
0001,CompanyX
0001,CompanyY
0001,CompanyZ
0002,Companya
0002,Companyb
0002,Companyc
0003,Company1
0003,Company2
If you use that filter I showed in my earlier post then when you multi-select with say Account 0002 and 0003 it will bring through to app2 Company a,b,c,1,2.
I have this error :
For set up :
