Hi - I am using the runner and conditional runner tool to run a workflow upon the successful completion of a previous workflow.
However, when a workflow "Fails" to run, I want to be able to see exactly what the errors are, so that they can be adjusted. I thought the log parser tool would show this, but when my workflow with the crew macros runs, it only says "workflow xyz" has failed and and the log parser doesn't show anything at all.
Is there a way to view the full errors?
Solved! Go to Solution.
Hi @changje2
Did you click on the Browse tool to check?
It should show a Table with Module Information, Message, MessageType, and all log entries.
Cheers,
Hi @changje2 if a workflow errors, then it will appear in the 'F' output of the conditional runner macro. If you connect your log parser to that output and view with a browse tool, you can see your errors
Hello - Thanks for the reply.
When I click on the browse, I get blanks. Please see below:
Ah...I was using the log parser and browse incorrectly....
Thank you so much for the visual guidance, much appreciated!