This site uses different types of cookies, including analytics and functional cookies (its own and from other sites). To change your cookie settings or find out more, click here. If you continue browsing our website, you accept these cookies.
The "block until done" tool works for a data stream level, which is saying when the last record comes, then the following procedures run.
But now the case is I am using a lot of "conditional run", I need to make sure a workflow starts running only when the previous workflow is finished, instead of parallel running. How can I do that?
You're probably looking for one of @MarqueeCrew 's solutions: the Runner Macros.
This topic explains it well how to use them.
Thanks for your answer, now I am using "conditional runner", but the workflows are parallel running even I put them into a chain, how can I change that?
I have over 10 workflows which take me over 6 hours to run the, so use the built- in "Events" can be too tedious and risky(forget to change/updates).
Have you tried to use a Block Until Done after each Runner Macro.