UiPath Connector - Missing Incoming Connection

[LuisMart]

Hello, i am trying to run a UiPath job, but the connector, v1.1.0 it is asking me for an incoming connection. 

I don't need anything here, so i am lost on how to make this to run. Version 1.0.1 ran well without incoming connection, but it shows the python error when putting the query into the server. That is why i changed to v1.1.0

Any ideas?

Thank you very much!

[alexnajm]

The connection is option as indicated by the grey connector! There likely just needs to be a process selection in the UIPath tool configuration

[LuisMart]

Thank you, but there are no incoming connections options there. Only the ones to connect to uipath's orchestrator, which are correct.

[alexnajm]

Hmm couple things:

1) is AMP engine enabled? UiPath | Alteryx Help

2) are all the parameters a configured as well? UiPath Connector for Alteryx Designer - RPA Component | UiPath Marketplace

[LuisMart]

1) Yes, AMP engine is enabled.

2) I do not need to put any parameters to run the job i need, so they are unchecked.

[apathetichell]

Disable amp. What version of Alteryx are you running?

[LuisMart]

If i disable AMP, then i get this error.

[apathetichell · Accepted solution]

1.1 is not compatible with 2021.3:

• Compatible with Alteryx Designer and Server 2021.4.2 Patch 4, 2022.1 Patch 2 and later.

[LuisMart]

Ok, thank you for that.

I was using v1.0.1, but Alteryx support suggested me to install v1.1.0.

The problem with v1.0.1 is that I cannot post it to the server as I received this another error:

I installed v1.0.1 as admin as one post suggests, for all users, but no luck there.

I opened a case with Alteryx support for that python error and they suggested me to install v1.1.0