Table tool not respecting Table width per column

[Joker_Hazard]

Hello everyone.

I am currently suffering from an issue related to table tool. When I try to adjust the column width, it does not respect the number I input.

How to make this easier? I mean, this is a recurrent issue that normally occurs in every automation I create. Even with "automatic" set up it still breaks the cell.

Thanks

[binu_acs · Accepted solution]

@Joker_Hazard If your table outputs connected to the render tool try to increase the paper size , in that way you can increase the size of each columns

[Joker_Hazard]

It worked, thanks!! However it seems like a workaround. I will put a "solved" at the of the day for you, because I would Alteryx team to comment about this. It might be a bug!!

Thanks in advance :)

[M_Schirmböck]

Thanks a lot, this was exactely the solution I was looking for :-)