Output Tool Error

[ljohns04]

Hello,

I get an error stating that there is an 'Output Tool Error' This only happens occasionally and not on a regular basis. There is only one output tool. There are 6 sheets being written to the same output file that goes through the 'Union' tool. There is also a blob tool that is used to configure together a template. 

It states how the error is because the output file is being used at the same time by two different processes. I do not know why this would be happening. Any information is greatly appreciated.

- Lance

[alexnajm]

Where are you writing to? In my experience it could be a slow network drive - it doesn't finish in time due to lag/slowness

[ljohns04]

Yes, I am writing to a network drive. It doesn't happen all the time, so it is hard to test if it is the network drive. 

[alexnajm]

You can change the paths to your Desktop temporarily for testing and see if you get the same issue!