Macros not readable in latest version

Question

Hi Community ,

I downloaded latest Alteryx Admin (2022)on my new VM(ver 2019) and started trail version. After that I tried to run my already created workflows, but macros were not read.

In my previous VM , Alteryx admin is licensed and workflows are running .

Do I have to login with license key for macros to be run or anything else to be done.

Thanks

philipmannering · Answer

Perhaps try opening the macros in the new version of Alteryx first, and saving them down >>> then open the workflow after the macros have been saved with the new version.

smoskowitz · Answer

Since this is a new install, did you map to where your Macros are located if that is relevant?

AngelosPachis · Answer

Hi @dikshit_luthra,

Do you get any error messages when opening up your workflows regarding your macros? If yes, can you add a screenshot of that message please?

Thanks,

Angelos