Installing Power BI Output Tool
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
I have downloaded the "Publish to Power BI" output tool from alteryx gallery. See screenshot below. After downloading and opening, it opens in Designer with the workflow below. I assume I should just run the workflow and that is what creates the new Connector? I can't seem to get this to work, can anyone help?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi @jmerritt - The workflow that you downloaded generates a PCXML file with links to downloads. However, if you will go back to the Gallery and follow instructions, you will be able to download an installation file directly:
To download the tool:
(1) Select Run.
(2) Select Run, again.
(3) The page will display available versions. Select a version to download the tool.
Installation is an yxi file that you will need to run. Then you will need to re-open your Designer. After the last step you should be able to see the tool in the Connectors tool palette:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
HI @jmerritt ,
In the Gallery, follow these steps:
1. Click on Run
2. Click on Run again
3. Select the version you want to download
4. You will see the yxi file downloading
5. Open it in Alteryx (just drag it in from the web browser to Alteryx) and install it.
After this you will have it available to you inside of Alteryx.
Pedro.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi, so wondering if you may assist, I have followed all of the steps as laid out in this post successfully. However, I get to a point in the install process where I receive this message:
I click on OK but when I go to the connector bar, this is all I see:
Is there something I am doing wrong? Any help would be greatly appreciated.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi @Bigmonki
We're you able to resolve this? I have the same issue. Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
@regros Hi, I had to have a support call in the end and manually load the files onto my laptop. Once it was installed, I then needed to amend the certificate in the library to allow it to communicate.
If you go tot he support section and book a call, they are really helpful.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Thank you!
![](/skins/images/6056C79A596CAB15526D64C598622101/responsive_peak/images/icon_anonymous_message.png)