Frozen for some minutes but not crashed

[Tkuehner]

Hi, after running a simple workflow (Text Input , select, browse) Alteryx freezes for 1-2 minutes, than works fine again till the next run.

If I turn the machine offline no issues occur at all. 

Any suggestions?

Cheers Tom

[patrick_digan · Accepted solution]

@Tkuehner What version are you running? That sounds like the same problem some folks were having with 2018.1.3 over here (and I think 11.8 was having similar issues). If possible, I would suggest upgrading to 2018.1.4 which was just released on Tuesday over at licenses.alteryx.com

For me personally, I noticed a few second delay on 2018.1.3. On an unrelated note, I switched to another machine and it didn't have the same delay. I am now running 2018.1.4 and it continues to perform fine.

[Tkuehner]

Hi I have 11.8.3 but I will try the latest version as propose by you.

[paultno]

I initially installed 2018.1 and it was EXTREMELY slow.  When switching to the prior version, it worked much better!

[Tkuehner]

It works fine with the latest version! 2018.1.4 Thank's for all  the answers!