Error: Designer x64: The Designer x64 reported: You found a bug

[Gautham_0999]

Hello Team, 

When i run the workflow i am getting an error. I have used 10 control containers as of now, the count will definitely go up for further additions. But when i turn off few containers and run the workflow - it perfectly works, when I turn on all the containers, i am getting the above error message. 

Have any of encountered similar issue and resolved it. 

Error : 

Warning: Designer x64: The Designer x64 reported: Disk space on temp drive running low. No browse everywhere data created.

Error: Designer x64: The Designer x64 reported: You found a bug and a crash report was automatically sent to Alteryx. Contact customer support for assistance. 

[abacon]

Yes i have gotten this many times, it usually is a memory issue on the machine. Here is what I would try:

1. Does it work on the server? (If applicable)

2. Turn off AMP engine and run. This is usually a good fix.

3. Are there any Cross Tab tools being used? I have found these will cause this error many times. If so, try to use a macro to perform the action in smaller pieces.

If these don't work, could you post the workflow so others may help debug?