CreW Macros, conditional runner error?

[Bigmonki]

Hi,

I am struggling to work out what is wrong with my workflow. I have a runner from the CreW Macro that starts off a chain, there are then several runners to the end.

Everything works fine, except one workflow, when I add this to the chain, it fails? If I run the workflow on it's own, no issues, if I run it from a "Runner" (starting chain), no issues, it's only when I insert it in the chain there is a problem.

I have inserted a "Wait a second" macro in case it needed the previous conditional runner to fully complete, I also added one after so it had time to complete it's run! 

This one workflow just will not run in a chain, only at the start or on it's own. Any ideas?

[Bigmonki · Accepted solution]

Hi All,

Fixed it, there was a single conversion error in the workflow that the runner didn't like. On it's own the workflow ran fine, but the runner was stopping it.