Conv Errors when using CReW Macros Runner

[abartoszek]

I have a workflow that runs clean with no conversion errors, but when I use a CReW Macros Runner to run the workflow I always get the message " Runner (3) Tool #2: The field "Field_1" was truncated in record #4".  Has anyone seen this before?   I saw some suggestions about adding a Select tool and increasing field sizes, but that hasn't had any impact.  

[FreeRangeDingo]

I know how to find the CReW macros and the run command tool, but I don't follow your instructions after Read Results.  Where is Read Results?

[jamshed23]

did not worked for me, i am still facing this issue, job failed from server

[jamshed23]

Could you share the screen shot