Conditional routing using Radio buttons: nothing happening

[subhajits11]

Hi,

I am trying to achieve enable disable tool container but where i did the mistake it is not working.

Thanks !

[NicholasM · Accepted solution]

Hey @subhajits11 ,

I believe the reason why this isn't functioning properly is due to the fact that there is no intended output at the moment, so nothing would be displaying if you ran it via an analytic app. (Also the workflow you attached the Nesting interface tools were not connected). 

I was able to get the workflow to run properly by adding a basic table and a render tool to create a temporary PDF based off the user's selection. Check this out to see if it fixes the issue.