Column Width and Heading Grouping

So I had this fixed at one point - I changed the sizing in the orange boxes on the far right so I know it can be fixed. The goal - In the output file - I would like column A to not be insanely wide. I always have to resize it when I open it. I also don't care for the 'vertical' grouping that is setup in those right hand orange boxes but I can't find a way to remove this without killing the hyperlink. So doing the second part of this ask - most likely will take care of the other.

Thank you in advance! Shelly

SkillsZip.yxzp

Workflow

Accepted answers

shpruitt

Thank you so much! Do you know how I can remove the 'vertical grouping' layout option but keep the hyperlink? I don't quite understand how they are connected (I stole that section from another workflow).

All comments

CharlieS

The most important thing to modify here is the Render tool paper size settings. All other size settings are secondary to this final setting. When you set the custom size of 60" wide, the render tool will fill that space first, and then consider any width settings you set in the preceding tools.

Also, if this is the only Table you are Rendering, the Layout tool is unnecessary. When you remove this tool, you're also removing another size calculation step which will make all other size adjustments a little more direct.

20191101-RenderWidths.yxmd

shpruitt

JokeFun

Hi @CharlieS In case of multiple tables, how to make it possible that each sheet can have the appropriate column width? One sheet may contain only two columns, while another may have more than 10.

Quick Links

This months top contributors

FláviaB 262

JORGE4900 235

caltang 177

DanM 167

IraWatt 157