Runner says it failed but the workflow inside has no error. HELP

Question

Hello, I am kind of new to this problem.

Workflow's scheduled on server. When it ran the third runner output its result to a FAIL but when I visited the workflow inside of it and reran again i found no errors. This is strange considering the upper two workflows ran successfully. The stranger thing is it says the result is failed but the errors were null.

However the workflow inside is successful

Any ideas?

This will help

Matt_D · Answer

Hi @TheaAbella000 I have seen this before too but it didn't impact me so I didn't raise. I think it must be one of the conversion errors / warnings being picked up as an error instead. Out of interest which tool(s) are causing the conversion errors and warnings?

I didn't do this but if you are confident you could hop back through the macros, you can then get to the original and change the path ran in the Run Command Tool from Adam's place holder to your new one to see what's happening.

Treyson · Answer

@MarqueeCrew