I'll try to communicate this question as best as I can.
During development of a workflow, I notice that slight configurations to tools in the workflow sometimes lead to the Alteryx wheel (Where Alteryx is processing something...) which tends to slow down development pretty significantly sometimes. Especially when I'm making several micro changes. One example, updating directory file paths on the 'Directory' tool or the 'Input Data' tool. While I am aware of the Options -> Advanced Options -> Workflow Dependencies feature, I only mean to represent this as an example. Configurations to other tools may also cause the persistent Alteryx Wheel to arise.
Anyways, the question: Is there a way to configure the designer to allow me control over these refreshes. Rather than them automatically occurring after each tool configuration I perform, I would prefer to make a batch of edits and then manually refresh them.
The feature I am discussing here would best be compared to Excels Formulas -> Calculation Options -> Manual
Thank you in advance for your help.
