Installing Power BI Output Tool

I have downloaded the "Publish to Power BI" output tool from alteryx gallery. See screenshot below. After downloading and opening, it opens in Designer with the workflow below. I assume I should just run the workflow and that is what creates the new Connector? I can't seem to get this to work, can anyone help?

Output

Power BI

Accepted answers

All comments

ArtApa

Hi @jmerritt - The workflow that you downloaded generates a PCXML file with links to downloads. However, if you will go back to the Gallery and follow instructions, you will be able to download an installation file directly:

To download the tool:

(1) Select Run.

(2) Select Run, again.

(3) The page will display available versions. Select a version to download the tool.

Installation is an yxi file that you will need to run. Then you will need to re-open your Designer. After the last step you should be able to see the tool in the Connectors tool palette:

pedrodrfaria

HI @jmerritt ,

In the Gallery, follow these steps:

1. Click on Run

2. Click on Run again

3. Select the version you want to download

4. You will see the yxi file downloading

5. Open it in Alteryx (just drag it in from the web browser to Alteryx) and install it.

After this you will have it available to you inside of Alteryx.

Pedro.

Bigmonki

@pedrodrfaria

Hi, so wondering if you may assist, I have followed all of the steps as laid out in this post successfully. However, I get to a point in the install process where I receive this message:

I click on OK but when I go to the connector bar, this is all I see:

Is there something I am doing wrong? Any help would be greatly appreciated.

Quick Links

This months top contributors

atcodedog05 19598

Qiu 15867

binu_acs 15708

MarqueeCrew 13708

apathetichell 13703