Block Until Done

Tearless

Hi, the process below is the inside of THE FAMOUS "Parallel Block Until Done". 

I get why the process is built this way except for the "block until done" tools... 

I would connect the sample tool to the second output connector of the first Block Until Done tool.. but it is connected to first output.. which I do not get it.

Also.. why do we need the second block until done? Isn't it independent from the first one, meaning that.. it does nothing more than just passing data through? Why do we even need it??

Please HELP

Emil_Kos

Hi @Tearless,

In my opinion, you don't need them. I would assume that during the development process someone used it and it was useful for them but now you can delete it. 

Like you said it isn't even connected correctly so just remove it and check if everything runs as expected.

Good Luck!

If this is helpful please mark my post as a solution!